Baracoda Barcode Reader Uživatelský manuál stáhnout pdf (Strana 5)

RoadRunners BRR-L Programming guide May 2006

2.3.2 Shutdown timers

There are two differents ‘shutdown timers’ :

- when connected timer : delay between the last scanned barcode and the switch off when the

scanner is connected to an host

- Not connected timer : delay between the last scanned barcode and the switch off when the

scanner is not connected to any host

It is possible to set those timers to ‘infinite’. In that case ; the scanner will stay all the time ON.

\VT\VTh\NUL\STX\FNC4\DEL\FNC4\DEL\FF\FF

Set shutdown timers to infinity

By default, timers value are :

when connected timer = 20 minutes

Not connected timer = 10 minutes

\VT\VTh\NUL\STX\DC4\LF\FF\FF

Set shutdown timers to default

2.3.3 No data loss mode and Baracoda Header

Baracoda header:

It is a proprietary data encapsulation. It is necessary to activate it to use the Baracoda keyboard emulation

(Kemul) and Hyper terminal.

The Baracoda header is enabled in default settings

No data loss mode:

Baracoda has developed a proprietary communication protocol in order to enhance the security of the Bluetooth

transmission.

Every barcode sent to the host must be acknowledged by the host (until then, the scanner will transmit it again

and again).

This acknowledgment is disabled in default settings. It is strongly recommended to set this protocol

acknowledgment on when using the scanner with the BaracodaManager.

Enables Baracoda header + ”No Data loss mode”

\VT\VTH\NUL\SOH\SOH\FF\FF

baracoda header + ACK

Enables the Baracoda header + “No Data loss

mode” OFF (*)

\VT\VTH\NUL\SOH\NUL\FF\FF

baracoda header

Disable Baracoda header + “No data loss mode”

OFF

\VT\VTH\NUL\SOH\STX\FF\FF

remove baracoda header

1 2 3 4 5 6 7 8 9 10 ... 28 29

Žádné komentáře

Baracoda Barcode Reader Uživatelský manuál Strana 5