Baracoda USB Plug & Scan User Guide
• The scanner has been programmed from its default status and it is not able to decode the
Code 128 symbology. Be aware that the pairing barcode is a code128 and so the scanner
shall stay in its default mode “Code128 on”
3.3
How to pair your BCM2604-L/BCM2604-F
1. Reset the scanner by taking out and replacing both batteries.
2. If the scanner has not been programmed to read the Code 128 symbology, scan the Code 128 active
barcode (“Code 128 on”). The scanner should beep. The LED should remain a single flashing light.
Immediately reset the scanner. This will clear the memory buffer and allow the pairing barcode to
operate correctly.
Code 128 on
for the BCM2604-L FOR THE BCM2604-F
3. Plug the dongle into the USB port of the computer.
& Scan dongle. It is possible that
5.
that pairs the scanner to the dongle.
4. Wait 5 seconds for the host computer to recognize the USB Plug
the host computer will not recognize the dongle: this can be corrected by going to the control panel
hardware wizard and searching for a USB HID device.
Do not scan any other barcodes except the barcode
read”
7. , the scanner will beep a second time: the LED on the scanner will start
8. d Word). Make sure the application can
9. ing barcodes. Please note that the USB Plug & Scan is not able to transmit 2D barcodes
3.4
How to pair your RoadRunners
1. Reset the scanner.
the USB port or into the RS232 port of the computer.
the RS232 dongle.
iring
5.
ar a beep and the BCL LED on the scanner will start double
Just ope and Word). Make sure the active cursor is where
ease note that The RoadRunners are set by the Plug and scan USB in the mode “no data loss mode” OFF.
t
se the RoadRunners with the BaracodaManager please remember to set this option in the
6. Scan the pairing barcode and scan it just once (you will immediately get a “good
confirmation beep from the scanner. In case you don’t get an immediate double beep, simply reset
your scanner and try again).
Within less than 20 seconds
double flashing green: you are now paired and connected! *
Open up the target application (such as Notepad, Excel an
accept data from a keyboard and the active cursor is where the user wants the barcode information to
be placed.
Start scann
with an amount of information bigger than 1080 characters.
2. Plug the dongle into
3. Wait 5 seconds for the host computer to recognize the USB Plug & Scan or
4. Do not scan any other barcodes except the barcode that pairs the scanner to the dongle (pa
barcode, available in the box of the dongle).
Scan the pairing barcode just once.
6. Within less than 20 seconds you will he
flashing green: you are now paired and connected!
n up the target application (such as Notepad, Excel
you want the barcode information to be placed and start scanning barcodes.
P
This implies that the reader will not bufferise barcodes if the barcodes are read when the reader is no
connected.
If you will u
BaracodaManager settings
© Baracoda 2005
(29 stránky)
(2 stránky)
(11 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce